Input Shaft, Loosening and Tightening

Input Shaft, Loosening and Tightening

Loosening

• The driveshaft can be checked and tightened without opening the refrigerant circuit. Refer to=> [ Drive Plate with Overload Protection, Checking Run-Out and Adjusting ] Adjustments.

- Remove the components that prevent access to the driveshaft. Refer to=> [ A/C Compressor with Drive Unit, Engine Code BAR ] A/C Compressor with Drive Unit, Engine Code BAR.

- Hold the A/C compressor driveshaft - A - in place using an open-end wrench and turn compressor drive unit - B - in the direction of the arrow - C -.





• Do not turn the driveshaft - A -.

• Driveshaft - A - can be slid into drive wheel through the boot - E - after loosening threaded connection.

• After installing the driveshaft - A -, check the boot - E - installation position.

Tightening

- Hold the compressor driveshaft - A - in place using an open-end wrench and turn the compressor drive unit - B - in the direction of the arrow - D - tightening specification 60 Nm.

- After tightening the compressor driveshaft, check the boot installation position - E -.