Headlamp: Service Precautions

HID Headlamps, Usage and Safety Precautions

Special tools, testers and auxiliary items required

• Protective Eyewear

• Gloves


• Never replace bulbs if you are not familiar with the procedures, safety precautions and tools.

- If repair work is performed on main headlamp with HID lamps, note the following:

• Notes on hazardous high voltage / currents.

• Notes on pressure, temperature and radiation / electric arc.

• Assembly notes for HID lamps.

• Disposal regulations for HID lamps.

Information On Dangerous High Voltage/Current


Control modules of lighting system, connectors or components in area of lamp socket carry hazardous high voltage.

The control module and igniter may be used only on the bulb.


• Turn off the ignition and all electric consumers and remove the key.

• Make sure all components have zero potential when working on headlamp system, even residual voltage after switching off headlamps must be discharged.

• Residual voltages are discharged by switching low beam on and off again after ignition key was removed.

• Make sure lamps cannot be switched on when working on headlamp system.

Notes On Pressure, Temperature and Radiation / Glare


• Lamp must only be operated in headlamp housing (protection against contact because of hot lamp, absorption of ultraviolet radiation, avoiding danger of glare, explosion protection).

• Glass cones of bulbs can become very hot - danger of burns!

• Avoid looking directly into light beam, since UV radiation of the HID lamp is approximately 2.5 times higher than that of standard Halogen lamps.

• Avoid looking into light beam (danger of glare); vision can be impaired for a longer period of time.


• Avoid contact with burst glass cone.

• H7 bulbs and HID bulbs (Xenon / Bi-Xenon) are under pressure and can burst when replaced - danger of injury!

• When removing and installing HID bulbs, always wear safety glasses and gloves.

Assembly Notes On HID Lamps


• Before replacing a bulb, the corresponding consumer must always be switched off.

• Turn off the ignition and all electric consumers and remove the key.

• Do not touch glass cone of bulb with bare fingers, use clean cloth gloves. The remaining fingerprint would evaporate due to the heat of the operated bulb and condense on the reflector which would impair headlamp luminosity.

• A bulb must only be replaced with one of the same version. Bulb identification can be found on bulb socket or glass cone.

• Harness connectors must engage correctly when installed and must be checked for proper connection.

Disposal Regulations For HID Lamps


• HID lamps must be disposed of as hazardous waste, never dispose of HID lamps via domestic waste.

• HID lamps contain metallic mercury (Hg) and traces of thallium, they must not be destroyed.

• These components must be returned for proper recycling in accordance with national legislation.

• Dispose of only in the designated containers at the responsible collection point.