HID Headlamp Control Module

HID Headlamp Control Module

• Left High-intensity Gas Discharge Lamp Control Module (J343) and Right High-intensity Gas Discharge Lamp Control Module (J344) is not capable of On Board Diagnostic (OBD).

• Illustrations depict replacement of High-intensity Gas Discharge Lamp Control Module at left headlamp.

• Replacement procedure of Left High-intensity Gas Discharge Lamp Control Module and of Right High-intensity Gas Discharge Lamp Control Module is the same.

Removal

- Turn off the ignition and all electric consumers and remove the key.

- Remove headlamp. Refer to => [ Headlamps ] Headlamps.

- Remove both mounting bolts - arrows - and remove HID headlamp control module - 1 - straight out of headlamp housing.






• The HID headlamp control module electrical connector is disconnected at the same time it is removed from the headlamps housing.

Installation

Install in reverse order of removal. Note the following:

• Make sure seals have proper seating when installing High-intensity Gas Discharge Lamp Control Module. It is destroyed by entry of water into headlamp.

- Check headlamp for function.

- Check the headlamp adjustment and correct it if necessary. Refer to Maintenance Procedures; Rep. Gr. 03.