High Beam Bulb

High Beam Bulb

• Left High Beam Headlamp (M30) and Right High Beam Headlamp (M32) can be checked via output Diagnostic Test Mode (DTM) of Vehicle Electrical System Control Module (J519). Refer to => [ Vehicle Electrical System, Output Diagnostic Test Mode ] Scan Tool Testing and Procedures.

• Illustrations depict replacement of High Beam Headlamp Lamp at left headlamp.

• Procedure to replace Left High Beam Headlamp and Right High Beam Headlamp is the same.

Removal

- Turn off the ignition and all electric consumers and remove the key.

- Remove headlamp. Refer to => [ Headlamps ] Headlamps.

- Remove cover cap - arrow - at headlamp housing.






- Disconnect connector - 1 - and by doing so press retaining tab in - direction of arrow -.






- Turn lamp socket in - direction of arrow - and remove it from headlamp.






• The lamp for fog light is joined permanently to lamp socket and cannot be replaced separately.

Installation

Install in reverse order of removal. Note the following:

• When installing cap, ensure proper seating. It is destroyed by entry of water into headlamp.

• Do not touch the glass of the light bulb, when installing. Your fingers will leave traces of grease on the glass which, when the light is switched on, will evaporate and cloud the glass.

- Check headlamp for function.

- Check the headlamp adjustment and correct it if necessary. Refer to Maintenance Procedures; Rep. Gr. 03.