Safety Precautions

Safety Precautions

To reduce the risk of personal injury and/or damage to the fuel injection and ignition system, always observe the following:

• The ignition must be turned off before connecting or disconnecting injection and ignition system wiring or tester cables.

• Do not touch or remove ignition wires when engine is running or turning at starter speed.

If special testing equipment is required during road test, note the following:

• Test and measuring instruments must be secured to rear seat and operated by a second person from this location.

If the vehicle is involved in a collision while testing and measuring equipment is operated from the front passenger seat, the person sitting in that seat could be seriously injured when the airbag deploys.

• If the engine is to be cranked at starting RPM without starting:

- Remove the ignition coil wiring harness cover strip.





- Disconnect the connectors from ignition coils 1 through 6 using the assembly tool (T10118).

- Place the assembly tool (T10118) on the locking button - arrow - and carefully pull the connector up.





- Remove the fuel pump fuse from the fuse holder.