Hydraulic Rear Lid Drive Motor Hydraulic Pump

Hydraulic Rear Lid Drive Motor Hydraulic Pump

Removing





- Remove left side wall trim.

- Remove left sill panel strip. Refer to

- Remove bolts - 2 - and remove bracket - 1 -.

- Fold up noise insulation - 3 -.

- Disconnect the connector - 6 -.

- Protect surrounding components from any hydraulic oil that may leak out.

- Pull clips - 5 - up - arrow a - until lines - 7 - can be loosened in - direction of arrow b -.

Installation

• A new bolt must always be used to install bracket.





- Push the lines - 7 - onto the connections - arrow a - until clips snap downward - arrow b - and engage.

- Make sure the lines - 7 - are securely attached to the connections - 4 - on the hydraulic pump.

- Connect connector - 6 -.

- Fold noise insulation - 3 - together and position bracket - 2 -.

- Tighten bolts - 1 -, tightening specification: 60 Nm.