Preparing Components for Adhesion

Preparing Components for Adhesion

- Remove any adhesive residue with Adhesive Remover (VAS 6349).

- Clean adhesion surface thoroughly with adhesive remover D 002 000 10 immediately prior to bonding on attachments.

• The bonding surfaces must be free of dust and grease and there must be no left-over adhesive on them.

- Now apply plastic primer (D 009 600) uniformly in one stroke using applicator (D 009 500 25).

• Air dry time approximately. 10 minutes

• Bodywork must be prepared for adhesion.

- Adhesive 2K adhesive (DA 004 600 A2) must be thinly and evenly applied on the primed surfaces of the components, using the double cartridge gun (VAS 5237).