Sunroof / Moonroof: Adjustments

Glass Panel Height Adjustment

Special tools, testers and auxiliary items required

• Torque wrench (V.A.G 1783)






- Remove the bellow. refer to => [ Sunroof Glass Panel ] Sunroof Glass Panel

- Loosen the bolts for the glass panel.

- Move the glass panel for the panorama sunroof into the "open" position.

- Move the glass panel for the panorama sunroof into the "closed" position.

- Perform glass panel height adjustment at the front and rear on both sides as follows:

Front Panel Adjustment:

- Dimension a - = 0 to 1 mm lower than assembly frame - 3 -.

- Tighten front bolts to 5.5 Nm.

Rear Panel Adjustment:

- Dimension b - = 0 to 1 mm higher than roof - 2 -

- First tighten the center, and then the rear bolts to 5.5 Nm.

• To achieve the best possible exterior optical characteristics, make sure that the adjustment on left and right sides is performed as evenly (symmetrically) as possible.

• Glass panel must not be higher than roof at any point at front or lower than roof at any point at rear.