Panorama Sunroof Glass Panel Drive

Panorama Sunroof Glass Panel Drive

Special tools, testers and auxiliary items required

• Torque wrench (V.A.G 1783)

Removing

- Remove the lamps and controls.

Only remove and install the panorama sunroof glass panel drive when the roof is closed (zero position).

Requirements for removing and installing the drive: the engine and the ignition must be off, remove the key and open the door.

- Turn off the engine and the ignition, remove the key, and open the door.

• This state must be maintained up to installation of the drive motor.

- Remove the bolts - 3 - and remove the drive for the panorama sunroof.






- Disconnect the connector - 2 - for the drive.

Installation

• The drive motor bolts are microencapsulated and must always be replaced, tightening specification 3.5 Nm.

Install in reverse order of removal.

- After installation has been performed, key is reinserted into the lock cylinder of the ignition/starter switch.

• Then the functionality test is performed.