Front Seat Cushion Cover and Upholstery

Front Seat Cushion Cover and Upholstery

This removal and installation procedure describes the left front seat cushion. The procedure is the same for the right front seat cushion.

If the upholstery, front seat cushion on front passenger side is replaced, the front passenger seat occupant sensor (G128) must always be replaced, too! Refer to => [ Front Passenger's Seat Occupied Sensor G128 ] Front Passenger's Seat Occupied Sensor G128.

Removing

- Mount the fixture for seat repair (VAS 6136) on the engine and transmission holder (VAS 6095).

- Remove the front seat. Refer to => [ Front Seat ] Front Seat

- Secure the seat to the fixture for seat repair (VAS 6136).

- Remove the front seat belt latch. Refer to => [ Front Seat Belt Latches ] Front Seat Belt Latches

- Remove seat cap. Refer to => [ Cover Cap ] Cover Cap

Electric Seat

- Remove electric seat front end trim. Refer to => [ Power Seat Front Side Trim ] Power Seat Front Side Trim

- Remove electric seat trim. Refer to => [ Power Seat Trim ] Power Seat Trim

- Remove electric seat trim bracket. Refer to => [ Power Seat Trim Bracket ] Power Seat Trim Bracket

Partially Electric Seat

- Remove partially electric seat trim. Refer to => [ Partial Power Seat Trim ] Partial Power Seat Trim

- Remove bracket and actuating lever, trim of partially electric/height adjustable seat. Refer to => [ Partial Power/Height-Adjustable Seat Trim Bracket and Operating Lever ] Partial Power/Height-Adjustable Seat Trim Bracket and Operating Lever

Height-Adjustable Seat

- Remove height-adjustable seat trim. Refer to => [ Height-Adjustable Seat Trim ] Height-Adjustable Seat Trim

- Remove bracket and actuating lever, trim of partially electric/height adjustable seat. Refer to => [ Partial Power/Height-Adjustable Seat Trim Bracket and Operating Lever ] Partial Power/Height-Adjustable Seat Trim Bracket and Operating Lever

Passenger Seat with Pass-Through

- Remove the front seat trim. Refer to => [ Passenger Seat Trim, with Pass-Through ] Passenger Seat Trim, with Pass-Through.

- Remove bracket and actuating lever, trim of partially electric/height adjustable seat. Refer to => [ Partial Power/Height-Adjustable Seat Trim Bracket and Operating Lever ] Partial Power/Height-Adjustable Seat Trim Bracket and Operating Lever

Seat without Height Adjustment

- Remove trim of seat (without height adjuster). Refer to => [ Seat Trim, without Height Adjustment ] Seat Trim, without Height Adjustment

- Remove bracket, trim, seat (without height adjuster). Refer to => [ Seat Trim Bracket, without Height Adjustment ] Seat Trim Bracket, without Height Adjustment

All Seats

- Remove front seat backrest. Refer to => [ Left Front Seat Backrest ] Left Front Seat Backrest

- Disengage profile - 1 - on both sides in rear area of seat frame.

- Disengage profile - 2 - on both sides from mount - 3 - on bottom side of seat frame.

- Disengage profile - 4 -.






- Disengage profile - 1 - from seat frame on both sides.

- Disengage profile - 2 - from seat frame on front side.






- Disengage profile - 1 - from seat frame on both sides.

- Roll up cover on sides - arrows -.






- Cut through all upholstery hooks - arrows - with a diagonal cutter.

- Remove cover - 1 - and upholstery - 2 - from seat frame - 3 -.






Installation

- To install, perform the steps used for removal in reverse order.

• When securing cover - 1 - to upholstery - 2 -, use upholstery clip pliers (V.A.G 1634).