FWD

Trailing Arm with Bracket

Special tools, testers and auxiliary items required

• Torque Wrench (40-200 Nm) (V.A.G 1332)

• Wheel Hub Support (T10149)

Removing

- Remove the wheel.

- Remove the coil spring. Refer to => [ Coil Spring ] Coil Spring.

- Remove the retainer - 1 -, by pressing out the inner pins - arrows A -.






- Remove the coupling rod - 2 - from trailing arm/wheel bearing housing.

- Remove the trailing arm bolts - arrows B -.

- Unclip the electrical wire from the bracket.

- Mark the installed position of the bracket to the body.

- Remove the bracket bolts - arrows -.






- Remove the trailing arm - 1 - with the bracket.

If the trailing arm is being replaced, the bracket must be removed from the arm.

- To do so, clamp the trailing in a vise so that the bracket - 1 - makes contact with the vise - arrow -.






- Remove the bolt - 2 -.

The installed position of the bracket to the trailing arm must then be adjusted.

Determining the Installed Position of the Bracket Relative to the Trailing Arm

Measure the dimension - a - from the center of the bolt to the outer edge of the bracket.






Dimension - a -: 57.5 +/- 1 mm.

1. Bracket

2. Trailing arm


- When dimension - a - has been adjusted, tighten the bolt.

Installing

Note the different tie rod versions when replacing the trailing arm. Refer to => [ Tie Rod Characteristics ] Procedures.

Note the allocation of the tie rods for the trailing arms. Refer to => [ Allocation of the Tie Rods for the Trailing Arms ] Procedures.

The threaded connections of trailing arm/wheel bearing housing must only be tightened when all other components of the respective wheel suspension have been already assembled. To tighten, the suspension must be unloaded. Only now do the trailing arm and wheel bearing housing move into the position required - arrows -.

Position: Threaded Connection of the Trailing Arm/Wheel Bearing Housing





Always perform the following work in the sequence given!

- Install the trailing arm to the wheel bearing housing with the bolts - arrows -, but do not tighten.






- Install the coupling rod - 1 - to the trailing arm/wheel bearing housing, do not tighten the nut yet.

- Raise the wheel suspension using the engine-/gearbox jack (V.A.G 1383 A) and wheel hub support (T10149) until the bracket makes contact with the body.

- Tighten the bracket bolts - arrows - at the old marks.






- Lower the wheel suspension using the engine-/gearbox jack (V.A.G 1383 A) and remove the wheel hub support (T10149) from the wheel hub.

- Install the coil spring. Refer to => [ Coil Spring ] Coil Spring.

- Tighten the trailing arm to wheel bearing housing bolts - arrows B - to specification, observe the required position of the components while doing so.






- Tighten the coupling rod nut - 2 - to the trailing arm/wheel bearing housing.

- Install the retainer - 1 -, by pressing in the inner pins - arrows A -.

- When installing the wire for the electrical parking brake, make sure the dimension - a - between the connector - 1 - and the retainer - 2 - is exact.






Dimension - a - = 150 mm

- Install the wheel and tighten the wheel bolts. Refer to => [ Wheel Bolt Tightening Specifications ] Wheel Bolt Tightening Specifications.

- Perform a vehicle alignment. Refer to => [ Vehicle Alignment ] Vehicle Alignment.

Tightening Specifications