Rear Window Regulator Motor

Rear Window Regulator Motor

• Removing and installing the right window regulator motor is described here. Removing and installing the left window regulator motor is identical.

Removing

- Remove the door trim panel.






- Secure the door window with adhesive tape to prevent it from falling down.

- Remove the bolts - 3 -.

- Disconnect the connectors - 2 -.

- Remove the window regulator motor with the control module - 1 - from the subframe.

Installation

- Attach the window regulator motor by gently moving the door window up and down so that the splines between the window regulator motor and the cable reel can mesh together.

Tighten the bolts - 3 - to the tightening specification: 3.5 Nm.

- Code the new window regulator motor using the Vehicle Diagnosis, Testing and Information System (VAS 5051 A).

- After coding, let the window regulator work in the one-touch up/one-touch down mode and pull the switch for 2 seconds. This way the window regulator motor recognizes its upper stop.

- Continue by performing the steps used in removal in reverse order.