Sunroof with Glass Panel Assembly Overview
Sunroof with Glass Panel Assembly Overview
1 Sunroof glass panel (one-piece safety glass)
• Sunroof Glass Panel, Removing => [ Sunroof Glass Panel ] Service and Repair
• Sunroof Glass Panel, Adjusting => [ Sunroof Glass Panel, Adjusting Height ] Sunroof Glass Panel, Adjusting Height
2 Panel seal
• Adjusting panel seal => [ Panel Seal, Adjusting ] Adjustments
• Seal joint at center in rear area.
• Panel Seal, Replacing => [ Panel Seal ] Service and Repair
3 Sun shade
• Sun Shade, Removing and Installing => [ Sun Shade ] Service and Repair
4 Bolt
• Screws are microencapsulated and must always be replaced after removing.
• Qty. 4
• 1.8 Nm
5 Spring glider
• Bolted on to sun shade.
• Qty. 4
• Can be replaced separately
• Removing => [ Sun Shade ] Service and Repair
6 Bellows
• For covering slotted guide rail.
• Removing and Installing => [ Bellows ] Bellows
7 Water channel
• Removing => [ Link ] Link
8 Guide locking hook
• Removed together with slotted rail
• Removing => [ Bellows ] Bellows
9 End piece, upper part
• Clipped to lower part of end piece.
• Removing => [ Bellows ] Bellows
10 End piece, lower part
• Can be replaced separately
• Use butyl adhesive sealing cord (AKL 450 005 05 ) for sealing.
11 Assembly unit
• Removing and installing installation unit => [ Assembly Unit ] Assembly Unit
• If necessary use special grease G 000 450 02 exclusively to grease guide channels, otherwise the functions cannot be guaranteed.
12 Bolt
• Screws are microencapsulated and must always be replaced after removing.
• Qty. 3
• 3.5 Nm
13 Emergency operation hex key
• The emergency operation hex key wrench has been omitted. A standard hex key wrench should be used for emergency operation.
14 Electrical drive motor
• Removing => [ Sunroof Glass Panel Drive Motor ] Service and Repair
• Drive Motor, Neutral Position, Adjusting => [ Sunroof Glass Panel Drive Motor, Adjusting ] Sunroof Glass Panel Drive Motor, Adjusting
15 Spring
• Qty. 2
• To open wind deflector.
• Clipped in on wind deflector and cannot be replaced individually.
• Removing => [ Wind Deflector ] Wind Deflector
16 Wind deflector
• Removing => [ Wind Deflector ] Wind Deflector
• Adjusting, on vehicles from 08.2005 > => [ Wind Deflector ] Wind Deflector
• The adjustable wind deflector should not be retrofitted
17 Bearing for wind deflector
• Qty. 2
• Clipped in on wind deflector and cannot be replaced individually.
• Removing => [ Wind Deflector ] Wind Deflector
18 Front guide
• Can be slid individually out of guide rail.
• Removing => [ Bellows ] Bellows
19 Rear guide, lower part
• Removed together with slotted guide rail.
• Removing => [ Bellows ] Bellows
20 Torx screw
• Torx T25
• Qty. 3 per side
• 5 Nm
21 Slotted guide rail
• Removing and Installing => [ Slotted Guide Rail ] Slotted Guide Rail
22 Spacer
• Removing and Installing => [ Slotted Guide Rail ] Slotted Guide Rail