Through 2009

Premium 7

Special tools, testers and auxiliary items required

• Trim Removal Wedge (3409)

• The part number for the radio is on a label on the radio housing.

• Deactivate the anti-theft protection when replacing the radio. Refer to => [ Electronic Anti-Theft
System, Deactivating ] Through 2009. Give the customer the new radio code.

• If the radio code is not known, you can retrieve it via the known systems. The radio serial number will is needed. It is on a label attached to the side of the radio. The serial number is also stamped in the side of the radio.

Removing

- If there is a CD still in the radio, remove it. Refer to the Operating Instructions.

- Switch off ignition, switch off all electrical consumers and remove ignition key.

- Remove the upper cover and vents from the center of the instrument panel. The screws under the center console should now be accessible.

- Remove screws - arrows - (1.5 Nm).






- Pry off the cover in the center console using a (3409) - arrows -.






- Remove the screws - arrows - (1.5 Nm) from the radio.






- Pull the radio out just far enough until the connectors on the back are accessible.

- Press together the connector lock in direction of - arrows -.






- Then swing mounting bracket up in direction of - arrow - and disconnect harness connector.






- Disengage harness connectors - arrows - from antenna connections and disconnect them.






Installing

- Connect the connectors on the radio making sure they engage.

- Push the radio straight into the instrument panel.

• Never push directly on the display or the buttons when inserting the radio.

- Install the 4 screws - arrows - (1.5 Nm) in the radio.






- Install the cover in the center console.

- Deactivate the anti-theft coding. Refer to => [ Electronic Anti-Theft
System, Deactivating ] Through 2009.

- Check the coding for the radio. Code it again if necessary. Refer to => [ Premium 7 Components, Adapting ] Premium 7 Components, Adapting.