Rear Door Panel: Service and Repair

Rear Door Trim

• Removal and installation of trim is described for right rear door. The same instructions apply for removal and installation of trim for the left rear door.

Removal

- Turn off the ignition.

Only Vehicles with Manual Window Regulators

- Remove window crank. Refer to => [ Window Crank ] Window Crank

- Pry upper section of grip shell - 1 - out of pull handle in door trim using (3409).

- Disconnect the window regulator switch wiring harness from the door trim panel.

- Remove the bolts - 2 - and - 3 - (1.5 Nm).

- Remove bolt - 4 - (2 Nm).

- Disengage door trim from mounts in lower area using (3392).

- Disengage door trim from mounts on the sides using (3392).

- Pull door trim vertically upward out of window shaft seal.

- Depending on vehicle equipment, disconnect wiring harnesses from door trim.

- Disengage the cable - 5 - from the interior door mechanism - 6 -.





Installation

- To install, perform the steps used for removal in reverse order.

• Before installing, inspect the securing clips for damage and replace if necessary.