Master Cylinder and Brake Booster Assembly Overview

Master Cylinder and Brake Booster Assembly Overview






1 ABS Control Module (w/EDL) (J104)

• Removal and installation, refer to => [ Control Module and Hydraulic Unit ] Control Module and Hydraulic Unit.

2 Bolt, 2 Nm + 0.8 Nm

• Use new bolts.

3 ABS Hydraulic Unit (N55)

• Removal and installation, refer to => [ Control Module and Hydraulic Unit ] Control Module and Hydraulic Unit.

4 Brake Line, 14 Nm

• Master brake cylinder/primary piston circuit to hydraulic control unit.

• Identification: diameter 6.5 mm and tube fitting with thread M 12 x 1.

5 Brake Line, 14 Nm

• Master brake cylinder/secondary piston circuit to hydraulic unit.

• Identification: diameter 6.5 mm and tube fitting with thread M 12 x 1.

6 Brake Line, 14 Nm

• To left front brake caliper.

• Identification: diameter 5.25 mm and tube fitting with thread M 10 x 1.

7 Brake Line, 14 Nm

• To right front brake caliper.

• Identification: diameter 5.25 mm and tube fitting with thread M 12 x 1.

8 Brake Line, 14 Nm

• To left rear brake caliper.

• Identification: diameter 5.25 mm and tube fitting with thread M 12 x 1.

9 Brake Line, 14 Nm

• To right rear brake caliper.

• Identification: diameter 5.25 mm and tube fitting with thread M 10 x 1.

10 Brake Booster

• Removal and installation, refer to => [ Brake Booster ] Brake Booster.

11 Bracket

• After installing, make sure it fits properly.

12 Bolt, 8 Nm

13 Rubber Insulation

14 Bolt, 8 Nm

15 Bracket

16 Rubber Insulation

• When installing the mount, make sure the rubber insulation does not push out of the bracket.

17 Nut, 20 Nm

18 Heat Shield

19 Nut, 8 Nm