Controls, Housing
Special Tools
Special tools, testers and auxiliary items required
• Thread Adapter from Kukko Support (22/1)
• Bracket (30-211 A)
• Thrust Piece (T10042)
• Drift (T10169) or (T10362)
• Thrust Piece (T40008)
• Hot Air Blower (V.A.G 1416)
• Thrust Piece (T10143) or
• Press Tool for Shaft Seal (T10180)
• Transmission Support (VW 353)
• Guide Piece (VW 436 A)
• Guide Pin (VW 439)
• Holding Fixture (VW 801)
• Guide Piece (10-15)
• Thrust Pad (3124)
• Bearing Driver (3264)
• Subframe Support Assem. Device (3290)
• Thrust Piece (T10203)
• Punch (VW 407)
• Punch (VW 411)
• Tube Trans. Drive Shaft (VW 426)
• Support Bracket (10-222 A/31)
• Thrust Pad 16.5/28 mm Dia. (VW 431)
• Triple Square Socket Driver (3357)
• Connecting Pin (T10027 A)
• Hose Clamp Pliers (V.A.G 1275)
• Sleeve (VW 423)
• Pulling Hook (T20143/1)
• Engine Support Bridge (10-222 A)
• Engine Support Basic Set (T40091)
• Transmission Support Jig (3336)
• Workshop Crane (VAS 6100)
• Thrust Block (T10083)
• Drip Tray for VAS 6100 (VAS 6208)
Special tools, testers and auxiliary items required
• Transmission Support (3282)
• Adjustment Plate (3282/33)
• Support Elements (determine when mounting the adjustment plate on the transmission support)
• Pin (3282/29)
• Torque Wrench (5-50 Nm) (V.A.G 1331)
• Torque Wrench (40-200 Nm) (V.A.G 1332)
• Engine/Transmission Jack (V.A.G 1383 A)
Special tools, testers and auxiliary items required
• Bracket (T10346)
• Engine Support Device (3300 A)
• Adapter (VW 771/40)
• Hose Clamps up to 25 mm Dia. (3094)
Special tools, testers and auxiliary items required
• Holding Plate (VW 309)
• Holding Fixture (VW 313)
• Transmission Support (VW 353)
• Thrust Tube (VW 455) or Sleeve (3160)
• Slide Hammer-Complete Set (VW 771)
• - 1 - Kukko Puller 12-14.5 mm (21/1)
• - 1 - Kukko Extractor 14.5-18.5 mm (21/2)
• - 1 - Kukko Extractor 23.5-30 mm (21/4)
• - 1 - Kukko Extractor 18.5-23.5 mm (21/3)
• - 3 - Kukko Separating Tool 5-60 mm (17/0)
• - 4 - Kukko Support (22/1)
• - 4 - Kukko Support (22/2)