Selector Handle

Selector Handle

For all handles, there is the possibility that the button can be pressed into the handle. Never install the handle when the button is pressed in.

- Pull the button out beyond its pressure point before removing.





- Prevent the button from being pressed in with a cable tie or wire.

- Remove the cover.

- Release the handle.





- Lock the handle again after installing it.

- Push the plastic piece under the handle.

- In new handles, remove the transport protection after disengaging.





- Disconnect the connector from the cover.

- Remove the handle upward.

Vehicles with the button - arrow - on the front of the handle





The button - arrow - must not be pushed in when removing and installing the handle.

- Should this happen, then unclip the handle trim upward.





- Press the small lever for cable rod - arrow - into groove before handle is installed.