Selector Lever and Mechanism with Cable, from 03.2009

Selector Lever and Mechanism with Cable, from 03.2009

• The selector mechanism and the selector lever cable cannot be separated from each other. Both are removed at the same time.





• After installation, the selector lever cable movement must be checked and adjusted.

- Move the selector lever into the "P" position.

- Remove the selector lever handle. Refer to => [ Selector Handle ] Selector Handle.

- Remove the center console.

- Disconnect the connector from the selector mechanism.

- Remove the 4 screws.





Tightening specification: 8 Nm.

- Disconnect the cable - arrows 1 - and then remove it from the cable bracket - arrow 2 -.





• Do not use pliers because the tabs on the cable bracket could break off.

• Do not bend the selector lever cable.

- Pry the cable - 1 - off the lever - 3 - using a open end wrench - 2 -.





- Lift the vehicle.

- Remove the exhaust system components underneath the heat shield.

- Remove the heat shield under the selector mechanism.

- Remove the selector mechanism.





Installation is performed in the reverse order of removal.

- Install the heat shield under the selector mechanism.

- Install the exhaust system.

- Adjust the selector lever cable after installing. Refer to => [ Selector Lever Cable, Adjusting ] Adjustments.