Selector Mechanism, through 02.2009: Overview

Overview

CAUTION!
Move the selector lever into the "P" position and set the parking brake before working with the engine running.





1 Shift Cover with Handle

• Do not remove the handle unnecessarily. For emergency release, only the cover must be removed. Refer to => [ Selector Lever, Manual Release ] Selector Lever, Manual Release.

• Pull the button past its pressure point before removing the handle. Secure the button with a cable tie or some suitable wire. This prevents the button from being pushed back into the handle accidentally.

• If the button is pushed in:

- Just before installing, pull out button beyond the pressure point (sense this by touch).

2 Selector Mechanism with Selector Lever

• Removing and installing, refer to => [ Shift Mechanism with Lever ] Shift Mechanism with Lever.

3 Bolt with Spring

• 3 Nm

4 Bolt

• Removing, refer to => [ Selector Lever Cable through 02.2009 ] Selector Lever Cable through 02.2009.

• Do not lubricate.

5 Securing Plate

• Always replace after removing.

6 Nut

• 9 Nm

• Quantity: 4

7 Shift Housing

• With seal.

8 Selector Lever Cable

• Do not grease cable.

• Removing and installing, refer to => [ Selector Lever Cable through 02.2009 ] Selector Lever Cable through 02.2009.

• Checking, refer to => [ Selector Lever Cable through 02.2009, Checking ] Testing and Inspection.

• Adjusting, refer to => [ Selector Lever Cable, Adjusting ] Adjustments.

9 Nut

• 8 Nm

• Quantity: 4