Body Control Module: Service and Repair

Comfort System Central Control Module

CAUTION!
• Turn off the ignition and all electrical consumers.

• Remove ignition key.

Removing

- Remove the glove compartment.

- Pull the retaining tab - 1 - on the comfort system central control module (J393) bracket in the - direction of the arrow - and slide the control module until the openings - 2 - are aligned above the openings - 3 -.





• Electrical connections can only be disengaged and disconnected when recesses - arrows - and bracket line up exactly.





- Release and disconnect electrical connections from comfort system central control module.

• The number of electrical connections depends on vehicle equipment level and market version.

- Remove the nuts - arrows -.





- Remove bracket with comfort system central control module.

- Pull retaining tab - 1 - in - direction of arrow B - and slide comfort system central control module - 2 - out of bracket in - direction of arrow A -.





Installing

Install in reverse order of removal, noting the following:

Harness connectors can only be connected and engaged when recesses - arrows - of harness connectors and bracket stand exactly over each other.





After installing a new comfort system central control module, it must be coded. Refer to --> [ Comfort System Central Control Module, Coding ] Comfort System Central Control Module, Coding.