Front Left Level Control System Sensor

Front Left Level Control System Sensor

Special tools, testers and auxiliary items required

• Torque wrench (VAG 1410)

Removing

• In order to be able to remove the front level control system sensor (G78) the steering wheel must be turned all the way to the right; this assures that there is enough clearance between the control arm and the stabilizer bar.

- Disconnect the electrical connector.





- Remove the bolt and the nut.

- Remove level control system sensor.

Installing

Installation is performed in the reverse order of removal. Observe the following when doing so:

• The level control system sensor lever must point toward the vehicle exterior.

• The threads on the vehicle level sensor must be installed into the front hole in the control arm. The tab on the vehicle level sensor retainer must lock into the rear hole in order to assure a correct installation position.

- Perform a basic setting of the headlamps. Refer to --> Vehicle Diagnosis, Testing, and Information System VAS 5051 in "Guided Fault Finding" function.

Tightening Specifications