Selector Shaft Oil Seal, Servicing

Selector Shaft Oil Seal, Servicing

Special tools, testers and auxiliary items required

• Tube (VW 423)

• Extractor lever (T20143/1)

• Sealing grease (G 052 128 A1)

- Pull off securing clip - 2 - and press relay lever - 3 - to the side out of mounting.





• If the relay lever cannot be removed, due to the transmission bracket, remove the selector cable from the relay lever. Guide the slide shoe out of the transmission selector lever.

- Remove nut - 4 - and remove transmission shift lever - 1 -.

- Pry out seal using pulling hook (T20143/1).





- Lightly oil new seal on outer circumference.

- Fill area between sealing lip and dust lip - arrow - halfway with sealing grease (G 052 128 A1).





- Drive in seal using sleeve (VW 423).





Installation is in reverse order of removal. Note the following:

• The transmission selector lever can only be installed in one position.

- Adjust selector mechanism --> [ Selector Mechanism, Adjusting ] Adjustments.

Tightening Specifications

Transmission shift lever to shift rod --> [ (item 17) Self-locking hex nut, 23 Nm ] Shift and Selector Cables