Shift Lever and Selector Housing Assembly Overview
Shift Lever and Selector Housing Assembly Overview
• Lubricate bearing areas and slide surfaces with grease (G 000 450 02).
1 Lock washer
• Removing and installing --> [ Removing and Installing Lock Washer ]
2 Bushing
3 Spring
4 Bushing
5 Torx screw, 5 Nm
6 Cover
7 Damper
8 Damper
9 Bearing shell
10 Shift lever guide
11 Damping washer
12 Gasket
• Between selector housing and floor
• Self-adhesive
• Adhered to selector housing
13 Shift lever
14 Selector housing
15 Bushing
16 Pivot pin
17 Guide bushing
18 Spring
• Installing --> [ Installing Spring ]
19 Selector bracket
20 Torx bolt, 5 Nm
21 Gasket
• Always replace
22 Base plate
• Bend open tabs to remove
• Always replace
23 Selector cable
• On selector bracket
• Removing and installing --> [ Selector and Shift Cables, Removing and Installing ]
24 Shift cable
• Removing from shift lever guide and installing on shift lever guide --> [ Selector and Shift Cables, Removing and Installing ]
25 Lock washer
• Always replace
26 Hex nut, tighten to 8 Nm.
• Quantity: 4
27 Bushing
• Only fits in one position
28 Lock washer
• Always replace
Selector and Shift Cables, Removing and Installing
- Remove lock washer from shift cable - A - and selector cable - B -.
To do this, lift up retainer with a screwdriver - arrow 1 - and press off lock washer - arrow 2 -.
- Remove shift cable - A - from shift lever mount.
- Remove selector cable - A - from selector bracket mount.
Removing and Installing Lock Washer
- To remove and install lock washer - arrow A -, push spacer bushing - arrow B - to stop with a screwdriver in direction of - arrow C - and pull off lock washer.
• Do not tilt bushing when pushing down.
• Groove in shift lever for lock washer must be visible.
• Carefully release tension on spring.
Installing Spring
- Insert spring so that leg - A - contacts upper part of pin - arrow -.
- Then pull leg - B - far enough downward so that it rests on underside of pin - arrow -.