Fuel Tank Door Unit, Wagon

Fuel Tank Door Unit, Wagon

--> [ Fuel Tank Door Unit ]

--> [ Fuel Tank Lid Unlock Motor ]

Fuel Tank Door Unit

Removing

- Open fuel filler lid.

- Remove fuel tank cap.

- Remove bolt - 4 -.

- Pull rubber piece of fuel tank lid unit - 2 - from fuel tank filler neck - 1 -.

- Pull fuel tank lid unit - 2 - with drain hose - 3 - toward rear and swivel fuel tank lid unit out of side panel.





Installing

- Insert drain hose - 3 - through opening in fuel tank lid unit - 2 - and pull drain hose through until it stops.

- Guide drain hose into side panel.

- Slide fuel tank lid unit - 2 - with hinge side first into side panel.

- Swivel fuel tank lid unit completely onto side panel.

Make sure that catches of fuel tank lid unit - 2 - at top and bottom engage correctly in the side panel.

- Pull rubber piece of fuel tank lid unit over filler neck and tighten bolt - 4 -.

Tightening specification for bolt - 4 -: 1.5 Nm

- Check correct function of unlocking components.





Fuel Tank Lid Unlock Motor

Removing

- Remove the fuel tank lid unit. Refer to --> [ Fuel Tank Door Unit ].

- Push aside the side trim panel - B - of the side luggage compartment trim - A -





- Pull the side luggage compartment trim - B -





- Disconnect harness connector - 2 - from Fuel Tank Lid Unlock Motor (V155) - 1 - through the opening in the side luggage compartment trim





- Press the rubber grommet - 4 - out of the side panel and remove the wiring harness - 3 -.

- Remove the Fuel Tank Lid Unlock Motor (V155) - 1 - in - direction of arrow -

Installing

- Guide the wiring harness - 3 - through the opening in the side panel.

- Secure the rubber grommet - 4 - on the side panel.

- Connect the connector - 2 -.

- Slide the Fuel Tank Lid Unlock Motor (V155) - 1 - opposite the - direction of arrow - onto the side panel.

- Install the fuel tank lid unit. Refer to --> [ Fuel Tank Door Unit ].

- Install the side trim panel.