Engine, Securing to Assembly Stand

Engine, Securing to Assembly Stand

Special tools, testers and auxiliary items required

• Lifting tackle (3033)

• Shop crane (VAS 6100)

• Engine and transmission holder (VAS 6095)

• Engine lateral bracket (T03001)

• Transport arm (T03002)

For performing work, secure the engine using the (T03001) to the (VAS 6095).

- Remove the transmission from the engine.

- Remove the clamp - 1 - for the wiring harness, remove bolts - 3 - and remove the heat shield - 2 -.





- Disconnect the electrical connectors - 1 - and - 2 - and remove the bracket - 3 - bolts - arrow -.





- Install the (T03002) as shown.





The pin - 1 - engages in the cylinder block. Tighten the knurled bolt - 2 - hand tight.

- Install the (T03001).





Tighten the bolts - 1 - and - 3 - to 40 Nm and bolt - 2 - to 25 Nm.

• The bolts are designed so that they cannot be lost.

• When removing, (T03001) must be held at tension in direction of withdrawal, otherwise the bolt - 1 - cannot be removed.

- Install the (3033) as shown and lift off using the (VAS 6100) from the (VAG 1383A).





- Secure the engine on the (VAS 6095).