Sunroof / Moonroof: Adjustments

Panorama Sunroof

Front and Rear Glass Panel Height, Adjusting

• Adjust the front glass sunroof panel only on the front edge and the rear glass sunroof panel on the rear edge.

• To achieve the best possible exterior optical characteristics, make sure that the adjustment on left and right sides is performed as evenly (symmetrically) as possible.

Check the height adjustment

- Use a depth gauge to check the adjustment of the front glass sunroof panel - 1 - and the rear glass sunroof panel - 2 -.





• Dimension - a - : 1.7± 0.8 mm

• Dimension - b - : 0.8± 0.8 mm

• Dimension - c - : 0.8± 0.8 mm

If the measured values deviate from the specified values, then the glass sunroof panel must be adjusted accordingly.

• Adjust the rear glass sunroof panel.

Adjust The Front Glass Sunroof Panel

• The glass panel height adjustment is to be performed after the glass panel has been closed out of sliding position.

- Remove the trim. Refer to --> [ Glass Panel ] Glass Panel

- Loosen both front left and right screws - 2 - for the glass sunroof panel - 1 - only.





- Close the glass sunroof panel.

- Adjust the glass sunroof panel - 1 - according to the illustration.





• Dimension - a - : 1.7± 0.8 mm

• Dimension - b - : 0.8± 0.8 mm

• Dimension - c - : 0.8± 0.8 mm

- Tighten the left and right screws to 5 Nm.

- Install the trim.

Adjust the rear glass sunroof panel

- Pull the inner seal - 3 - slightly toward the inside where shown - arrow - and loosen the screws - 2 - on the rear glass cover - 1 -





- Adjust the glass sunroof panel - 2 - according to the illustration.





• Dimension - a - : 1.7± 0.8 mm

• Dimension - b - : 0.8± 0.8 mm

• Dimension - c - : 0.8± 0.8 mm

- Tighten the screws to 5 Nm.