Transmission Output Speed Sensor

Transmission Output Speed Sensor

CAUTION!
Do not run engine or tow vehicle with pan removed or when there is no ATF in transmission.

• The valve body and wiring harnesses can also be removed when transmission is installed.

• Moisten O-rings with ATF before fitting. Other lubricants lead to malfunction of transmission hydraulics.

• Always replace a valve body which is fouled or faulty.

• Do not use fluffy cloths.

• After pan has been installed, the ATF level must be checked and topped off --> [ ATF Level, Checking and Filling ] Service and Repair.

Removing

- Remove valve body --> [ Valve Body ] Service and Repair.

- Remove bolt - 2 - from Transmission Output Speed (RPM) Sensor (G195).





- Pull sensor out of transmission.

Installing

Install in reverse order of removal. During this step, observe the following:

- Press sensor into transmission to stop.

- Tighten bolt - 2 - for Transmission Output Speed (RPM) Sensor (G195) to specification: --> [ Tightening Specifications ] Tightening Specifications.

- Install valve body.