Manual Transmission - Control, Housing
Special Tools
Special tools, testers and auxiliary items required
• Holding plate (VW 309)
• Transmission support (VW 353)
• Drift (VW 295)
• Driving sleeve (VW 244 B)
• Heat gun (V.A.G 1416)
• Torque Wrench (V.A.G 1331)
• (Stehbolzen M 8 x 100 mm)
Special tools, testers and auxiliary items required
• Bracket (30-211A)
• Driver (32 - 111)
• Thrust piece (T10030/4)
• Puller (T10309)
• Puller (T10040)
• with pulling hook (T10040/2)
• Torque Wrench (V.A.G 1332)
Special tools, testers and auxiliary items required
• Drift (VW 295)
• Adapter (VW 295 A)
• Thrust pad (VW 447 H)
• Thrust pad (VW 512)
• Tube (2040)
• Thrust piece (VW 454)
Special tools, testers and auxiliary items required
• Puller (VW 228 B) (not needed with this transmission)
• Drift (VW 222 A) (not needed with this transmission)
• Seal installer set (3066) (spindle from assembly device)
• Thrust pad (3124) (seal and sleeve are designed as two parts)
• Slide hammer (VW 771) (seal and sleeve are designed as one part)
• Pulling hook (VW 771/37) (seal and sleeve are designed as one part)
Special tools, testers and auxiliary items required
• Engine support bridge (10 - 222 A)
• Adapter (10 - 222 A / 8)
• Additional hooks (10 - 222 A /2)
• Adapter (10 - 222 A /3)
• Adapter (10 - 222 A /16)
• Pin (3282/29)
• Transmission support (3282)
Special tools, testers and auxiliary items required
• Adjustment plate (3282/39)
• Engine/transmission jack (V.A.G 1383A)
• Torque Wrench (V.A.G 1331)
• Torque Wrench (V.A.G 1332)
• Transmission support jig (3336)
• Grease (G 000 450 02)
• Grease for clutch disc splines (G 000 100)
Special tools, testers and auxiliary items required
• Pressure plate (VW 402)
• Thrust piece (3290/1)
• Alignment fixture (3301)
• Thrust piece (VW 431)
• Spacer sleeve (VW 472/2)
• Drift (10 - 206)
Special tools, testers and auxiliary items required
• Pry lever (80-200)
• Assembly drift (10 - 508)
• Tensioning device (2070)
• Hose clamp pliers (V.A.G 1275)
• Locking pin (T10027 A)
• Thrust pad (T10148) (seal and sleeve are designed as one part)
• Tube (T10203)
• Tube (VW 423)
• Pressing Support (T10083)
