Front Seat

Front Seats

Front Seat

CAUTION!
Prior to working on the electrical system: disconnect the battery ground cable.

Removal

• Due to equipment variations, small deviations must be considered during removal and installation.

• Obtain the radio code before disconnecting the battery.

New version





- Push seat forward.

- Unclip cap - 10 - from the inner seat rail and remove bolt - 9 -. Unclip cover strip - 8 - at the rear - arrow A - and remove toward the rear - arrow B -.

- Unclip cap - 2 - from the outer seat rail and remove bolt - 3 -. Unclip cover strip - 4 - at the rear arrow - C - and remove toward the front arrow - D -.

Old version





- Unclip cover strip - 1 - from the rear inner seat rail arrow - A - and remove arrow - B -.

- Unclip cover strip - 5 - from the rear outer seat rail arrow - C - and remove arrow - D -.

Continuation for all vehicles





- Slide seat toward rear.

- Remove bolts - 6 - (23 Nm) or nuts - 7 - (23 Nm).

- Push seat back out of guide rail.





• Before disconnecting the connector for the ignition and ground wire of the airbag, the technician must electrostatically discharge him/herself (touch door striker plate or pin briefly).

- Disconnect connector for side airbag - 1 - from connector station - 2 -.

- If installed, disconnect connector for seat heater - 3 - from connector station.

- Connect connector - 4 - (airbag adapter (VAS 5094)) into connector housing - 5 -.

Installation

To install, perform the steps used in removal in reverse order.

• After connecting battery, vehicle options (radio, clock, electric window regulator) must be checked according to repair information and/or user manual.

• If the airbag indicator lamp (K75) indicates a malfunction after installation, the DTC memory must be erased using the (VAS 5051) and check again.