Heating and A/C Passenger Compartment Component Overview
Heating and A/C Passenger Compartment Component Overview
CAUTION!
Before beginning repairs on the electrical system:
• Obtain the anti-theft radio security code.
• Switch off all electrical consumers.
• Switch off ignition and remove ignition key.
• Disconnect negative ( - ) battery terminal.
• When disconnecting and reconnecting battery terminals, observe all applicable Notes and torque specifications, as well as instructions on performing OBD program and electrical system function checks as specified.
CAUTION!
Immediately plug open connections on A/C components to prevent dirt and moisture contamination.
• Before carrying out any work on the A/C refrigerant system, refer to A/C refrigerant system safety measures => [ Safety Precautions ] Service Precautions.
• System components identified with an * must only be serviced or replaced after discharging refrigerant system. Use Kent Moore ACR4 or equivalent.
1 Heating and A/C controls
• With A/C Evaporator Temperature Switch (E33)
• With Fresh Air Blower Switch (E9)
• With Fresh Air Blower/Recirculated Air Switch ( E184)
• Removing and installing => [ Heating and A/C Controls ] Heating and A/C Controls
• Assembly => [ Heating and A/C Controls Component Overview ] Heating and A/C Controls Component Overview
2 Dust and pollen filter
• Removing and installing => [ Dust and Pollen Filter ] [1][2]Dust and Pollen Filter
3 Side window air outlet
• Removing => [ Side Window Air Outlets ] Side Window Air Outlets
4 Side air outlets
• Removing => [ Side Air Outlets ] Side Air Outlets
5 Center air outlet console
• Removing => [ Center Air Outlet Console ] Center Air Outlet Console
6 Instrument panel cross member
• Loosening and tightening => [ Instrument Panel Crossmember ] Instrument Panel Crossmember
7 Fresh/Recirculating Air Door Motor (V154)
• Removing and installing => [ Fresh/Recirculating Air Door Motor ] Service and Repair
8 Fresh Air Blower (V2)
• Removing and installing=> [ Fresh Air Blower ] Service and Repair
9 Fresh Air Blower Series Resistor With Fuse ( N24)
• First remove Fresh Air Blower (V2) => [ Fresh Air Blower ] Service and Repair
10 Intermediate duct
11 Cables
• Installing and adjusting => [ Heating and A/C Cables Component Overview ] Heating and A/C Cables Component Overview
12 Rear footwell duct
13 Gasket
14 Connecting duct
• With front footwell air outlet
• Removing => [ Connecting Duct ] Service and Repair
15 Heater/evaporator unit*
• Disassembly and assembly => [ Heater/Evaporator Unit ] Heater / Evaporator Unit
16 Heater core*
• Removing => [ Heater/Evaporator Unit ] Heater / Evaporator Unit, heater/evaporator unit, disassembly and assembly
• Always use new coolant after replacement
17 Heater core/bulkhead seal
• Note installation position => [ Heater Core Bulkhead Seal, Installation Position ] Heater Core Bulkhead Seal, Installation Position
18 Defroster duct
• Replacing:
• Remove instrument panel
• Loosen instrument panel cross member=> [ Instrument Panel Crossmember ] Instrument Panel Crossmember.
19 Instrument panel
• Removing and installing
20 Center air outlet duct
21 Defroster air outlet panel
• Removing => [ Side Window Air Outlets ] Side Window Air Outlets