Roof Antenna
Antennas
Roof Antenna
• The roof antenna is available in dummy, shark fin or 16V antenna designs.
• The following procedure is described for the shark fin roof antenna. The procedure is similar for the dummy and 16V antenna designs.
Removing
- Remove C-pillar trim..
- Remove both rear grab handles under roof.
• On vehicles with side curtain airbag, molded headliner must be removed.
•
- Carefully lower molded headliner slightly in rear area.
- Remove nut - 2 -.
• Depending on antenna version, there may be up to 3 connectors.
Golf Sedan
- Disengage connectors - arrows -, disconnect them and remove roof antenna.
Golf Plus
- Disengage connectors - arrows -, disconnect them and remove roof antenna.
Connector with violet housing is telephone wire connection.
Connector with blue housing is navigation system wire connection.
The third possibility is a auxiliary heater remote control connector.
Installing
Install in reverse order of removal.
• When inserting roof antenna, ensure gasket is properly seated. Both guide protrusions of gasket must be seated in the appropriate holes - arrows - in antenna base.
• When inserting roof antenna, make sure antenna wires - 1 - are routed correctly through the wire pass-through in mounting nut - 2 -.