Housing

Housing

• Removing and installing is described only for the housing. Removing and installing lock cylinder is similar

Removing

- Pry out cover cap in front of bolt - 1 -.





- Pull door handle - 2 - in - direction of arrow - and turn screw - 1 - with socket wrench (T 10072) until housing - 3 - can be removed.

Installing

- Insert housing - 3 - in right angle - arrow - into door handle bearing bracket.





Door handle - 2 - must make contact only lightly at door plate.

- Now install screw - 1 - into bearing bracket using socket wrench (T 10072).

Door handle - 2 - engages again into housing - 3 - with a very audible click.

• During installation, housing must be pressed onto door plate. The door handle rests only lightly against the door panel.

Further installation is in reverse order of removal.

• Then a function test must be performed with door open, since the door cannot be opened if release is not correctly adjustment or clipped in.