Rear Housing

Housing

• Removing and installing is described only for the right housing. Removing and installing the left housing is similar

Removing

- Pry out cover cap in front of bolt - 1 -.





- Pull door handle - 2 - in - direction of arrow - and turn screw - 1 - with socket wrench (T 10072) until housing - 3 - can be removed.

- Remove housing - 3 - at right angle to door from door handle bearing bracket.

Installing

- Insert housing - 2 - at right angle into door handle mounting bracket.





Door handle - 1 - must make contact only lightly at door plate.

- Now install screw - 3 - into bearing bracket using socket wrench (T 10072).

The door handle engages in the lock cylinder housing with a very audible click.

• During installation, housing must be pressed onto door plate. The door handle rests only lightly against the door panel.

- Continue by performing the steps used in removal in reverse order.

• Then a function test must be performed with door open, since the door cannot be opened if release is not correctly adjustment or clipped in.