Coil Spring

Front Wheel Drive

Coil Spring

Special tools, testers and auxiliary items required

• Spring Compressor Kit (V.A.G 1752)

• 2 Spring Holders (80-165 mm) (V.A.G 1752/4)

• Adapter (V.A.G 1752/9)

Removing

- Remove wheel.

- Insert spring compressor - 3 -.





CAUTION!
Make sure that coil spring is seated correctly in (V.A.G 1752/4 ) - 2 - (danger of accident).

- Use a wrench or a reversible ratchet to tighten spring compressor.

- Compress coil spring until it can be removed.

- Remove spring.

1. Spring holder (V.A.G 1752/4)

2. Adapter (V.A.G 1752/9)

3. Spring compressor (V.A.G 1752/1)

Installing

Observe installation position!

The spring start - arrow - must touch bottom of spring seat.





- Install spring together with spring seat.

- Spring seat has a pin on bottom.

- This pin is inserted into hole of lower transverse link - arrow -.





- Then insert spring seat at top into upper spring end.

- Relieve tension on spring, place upper spring seat onto tab of chassis when doing this.

- Remove spring tensioner.

- Install wheel and tighten. Refer to => [ Wheel Bolt Tightening Specification ] Specifications.