Rear Lid Tail Lamps

Tail lamps

Rear Lid Tail Lamps

Removing

- Switch off ignition, switch off all electrical consumers and remove ignition key.

- Unclip cover - 1 - in direction of - arrow - from panel.





- Remove connector - 1 - in - direction of arrow -.





- Remove lower rear lid trim.

- Remove rear lid taillamp assembly mounting nuts - 1 -.





- Remove taillamp assembly.

Installing

Install in reverse order of removal, noting the following:

- Secure washer - 2 - using a glue dot (e.g. Loctite) before inserting onto bolt head - 1 - to prevent them from falling into body.





- Insert washers - 2 - onto bolt head - 1 -.

- Tighten the mounting nuts - 1 - to the specification. Refer to=> [ Specifications ] Specifications.





- Check the gap dimension to the body after installing the tail lamp assembly.