Drive Belt: Locations
Ribbed Belt Pulley, Denso A/C Compressor Assembly Overview
NOTE:
- This type of ribbed belt pulley is installed on "7SEU17C" A/C compressor.
- Different versions of the ribbed belt pulley may be installed, depending on A/C compressor construction type and engine version.
- Ribbed belt pulley
1 - Cap
2 - Circlip
- Remove carefully using a small screwdriver or needle-nose pliers (pay special attention to ribbed belt pulley when doing this)
3 - Guide cage
4 - Circlip
- always replace
- install on correct side (flat side toward A/C compressor)
5 - Spacer
6 - Ribbed belt pulley
- the ribbed belt pulley is made of plastics and is sensitive to impact, be especially careful when handling it
7 - A/C Compressor
- depending on engine and market version, different versions can be installed
- Clean A/C compressor flange before sliding on ribbed belt pulley.
8 - Rubber element
- Qty. 6
- Remove ribbed belt pulley from A/C compressor input shaft, dampens vibration and noise
- for installation, lightly coat rubber elements, e.g. with tire mounting paste or a soap solution (as a lubricant)