Power Seats, Power Seat Switch

Power Seat Switch

Removal






- Disconnect the negative battery cable.

- Remove the seat cushion side shield (3). Refer to => [ Seat Cushion Side Shield, Outboard ] Seat Cushion Side Shield, Outboard.

- Disconnect the power seat switch electrical harness connector (4).

- Using a small flat bladed tool, gently release the tabs (1) securing the power seat switch (2) and separate the switch from side shield (3).

Installing






- Position the power seat switch (2) onto the seat cushion side shield (3). Gently apply pressure to the switch until the tabs (1) are fully seated into place.

- Connect the power seat switch electrical connector (4).

- Install the seat cushion side shield. Refer to => [ Seat Cushion Side Shield, Outboard ] Seat Cushion Side Shield, Outboard.

- Connect the negative battery cable.

- Verify normal operation of the power seat assembly.