Terminal

Terminal

Removing

- Follow steps for removing terminals described in the connector removal section. Refer to => [ Connector ] Connector.

- Cut the wire 6 inches from the back of the connector.

Installing

- Select a wire from the terminal repair kit that best matches the color and gage of the wire being repaired.

- Cut the repair wire to the proper length and remove 1/2 inch of insulation.

- Splice the repair wire to the wire harness (see wire splicing procedure). Refer to => [ Wiring Harness ] Wiring Harness.

- Insert the repaired wire into the connector.

- Install the connector locking wedge, if required, and reconnect the connector to its mating half/component.

- Re-tape the wire harness starting at 1 1/2 inches behind the connector and 2 inches past the repair.

- Connect the negative battery cable and test all affected systems. Refer to => [ Battery, Disconnecting and Connecting ] Tools and Equipment.