B142F

B142F - Satellite Radio Antenna Not Connected

For a complete wiring diagram, refer to.

• When Monitored: With the ignition on and the satellite radio in seek mode.

• Set Condition: With the radio in seek mode for two loops around the band. The radio does not detect an antenna connection or does not receive a radio satellite signal.






Test Step 1 - Test Antenna

• Turn the ignition OFF.

• Disconnect the satellite radio antenna connector.

• Inspect the satellite radio antenna connection.

Was the antenna connection clean and secure?

Yes

• Go to Test Step 2.

No

• Repair the antenna connection as needed.

• Perform the Body Verification Test. Refer to => Non-DTC Based Diagnostics. Body Interior

Test Step 2 - Satellite Radio Antenna

• Using the satellite radio antenna service information, test the antenna.

Is the Antenna ok?

Yes

• Go to Test Step 3.

No

• Repair or replace the antenna assembly as necessary.

• Perform the Body Verification Test. Refer to => Non-DTC Based Diagnostics. Body Interior

Test Step 3 - Satellite Radio

• Reconnect all previously disconnected components.

• Move vehicle outside approximately 30ft. (9.14m) from any structure.

• Turn the ignition and radio ON.

• With the scan tool, erase the audio DTC's, put the satellite radio in seek up and down mode for 2 loops around the band cycle before proceeding.

• With the scan tool, read the audio DTC's.

Did this DTC reset?

Yes

• Replace the Satellite Radio.

• Perform the Body Verification Test. Refer to => Non-DTC Based Diagnostics. Body Interior

No

• Test Complete.