B1E3F

B1E3F - 3rd Row Seat Fold Switch - Stuck






For a complete wiring diagram, refer to.

• When Monitored: Continuously.

• Set Condition: When the power rear folding seat module senses the fold seat switch FOLD input for longer than 50 seconds, this code will set.






Test Step 1 - Test For Intermittent Condition

• Turn the ignition ON.

• With the scan tool, erase all DTCs.

• Operate the Power Rear folding seat switch fold/tailgate button several times.

• With the scan tool, read DTCs.

Does the scan tool display this DTC?

Yes

• Go to Test Step 2 => [ Test
Step 2 - Power Folding Seat Switch Stuck ]

No

• The condition that caused this symptom is currently not present. Check for an intermittent condition by inspecting the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also, inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals. Repair as necessary.

• Perform Power Folding Seat System Verification Test. Refer to => Non - DTC Based Diagnostics. Power Folding Seat System Verification Test

Test Step 2 - Power Folding Seat Switch Stuck

• With the scan tool, erase all DTCs.

• Disconnect the power folding seat switch harness connector.

• Turn the ignition ON.

• With the scan tool, read DTCs.

Does the scan tool display this DTC?

Yes

• Go to Test Step 3 => [ Test
Step 3 - Fold/Tailgate Switch MUX Circuit Short to Seat Recliner Switch
Return ]

No

• Replace the power folding seat switch.

• Perform Power Folding Seat System Verification Test. Refer to => Non - DTC Based Diagnostics. Power Folding Seat System Verification Test

Test Step 3 - Fold/Tailgate Switch MUX Circuit Short to Seat Recliner Switch Return






• Turn the ignition OFF.

• Disconnect the C392 seat in - line harness 12 way connector.

• Measure the resistance between the fold/tailgate switch MUX and the seat recliner switch return circuit at the switch connector.

Is the resistance above 10k ohms?

Yes

• Go to Test Step 4 => [ Test
Step 4 - Fold/Tailgate Switch MUX Circuit Short to Ground ]

No

• Repair the fold/tailgate switch MUX circuit for a short to the seat recliner switch return circuit.

• Perform Power Folding Seat System Verification Test. Refer to => Non - DTC Based Diagnostics. Power Folding Seat System Verification Test

Test Step 4 - Fold/Tailgate Switch MUX Circuit Short to Ground






• The ignition is Off.

• Measure the resistance between ground and the fold/tailgate switch MUX circuit at the switch connector.

Is the resistance above 10k ohms?

Yes

• Gain access to and check the fold/tailgate switch MUX wire in the seat harness to the power rear folding seat module for a short to ground condition or to another circuit. If OK, replace the power rear folding seat module.

• Perform Power Folding Seat System Verification Test. Refer to => Non - DTC Based Diagnostics. Power Folding Seat System Verification Test

No

• Repair the fold/tailgate switch MUX circuit for a short to ground.

• Perform Power Folding Seat System Verification Test. Refer to => Non - DTC Based Diagnostics. Power Folding Seat System Verification Test