11-Adjustable Pedal Sensor - Circuit Short to Ground

B1ED1-11-Adjustable Pedal Sensor - Circuit Short To Ground






For a complete wiring diagram, refer to.

• When Monitored: Continuously.

• Set Condition: The Memory Seat Module detects a low signal circuit voltage that is not within voltage specification from the Adjustable Pedals Sensor.






Test Step 1 - DTC ACTIVE?

• This DTC must be active for the results of this test to be valid.

• Turn the ignition on.

• With the scan tool, record and erase DTCs.

• Cycle the ignition switch from off to on.

• Cycle the Adjustable Pedals Switch forward and rearward.

• With the scan tool, read DTCs.

Does the scan tool display: B1ED1-11-ADJUSTABLE PEDAL SENSOR- CIRCUIT SHORT TO GROUND?

Yes

• Go to Test Step 2 => [ Test Step 2 - CHECK CONNECTOR/TERMINAL FOR DAMAGE ]

No

• Perform the APS Intermittent Condition Test. Refer to => Non-DTC Based Diagnostics. APS Intermittent Condition Test

Test Step 2 - CHECK CONNECTOR/TERMINAL FOR DAMAGE

• Check all terminals for broken, bent, pushed out, or corroded terminals.

• Turn the ignition off.

• Inspect the Memory Seat Module C1 harness connector, Adjustable Pedals Motor, and Adjustable Pedals Motor harness connector.

Is the Adjustable Pedals Sensor or any of the connectors/terminals damaged?

Yes

• Repair as necessary.

• Perform the APS Verification Test. Refer to => Non-DTC Based Diagnostics. APS Verification Test

No

• Go to Test Step 3 => [ Test Step 3 - CHECK (G13) ADJUSTABLE PEDALS SENSOR SUPPLY CIRCUIT
FOR A SHORT TO GROUND ]

Test Step 3 - CHECK (G13) ADJUSTABLE PEDALS SENSOR SUPPLY CIRCUIT FOR A SHORT TO GROUND







• Disconnect the Memory Seat Module C1 harness connector.

• Disconnect the Adjustable Pedals Motor harness connector.

• Using a 12-volt test light connected to 12-volts, probe the (G13) Adjustable Pedals Sensor Supply circuit at the Memory Seat Module C1 harness connector.

Does the test light illuminate brightly?

Yes

• Repair the (G13) Adjustable Pedals Sensor Supply circuit for a short to ground.

• Perform the APS Verification Test. Refer to => Non-DTC Based Diagnostics. APS Verification Test

No

• Replace and reprogram the Memory Seat Module.

• Perform the APS Verification Test. Refer to => Non-DTC Based Diagnostics. APS Verification Test