Video Entertainment System (VES3)

B210D-Battery Voltage Low

For a complete wiring diagram, refer to.

• When Monitored: With the ignition on.

• Set Condition: Battery voltage less than 10 volts for more than 20 seconds.






Test Step 1 - CHECK FOR ANY POWERTRAIN CONTROL MODULES DTCS

• Make sure the Battery is in good condition. Using the Battery Tester, test the Battery before continuing.

• Inspect the vehicle for after market accessories that may exceed the Generator System output.

• Make sure the generator drive belt is in good operating condition.

• Inspect the fuses in the IPM. If an open fuse is found, use the wire diagram/schematic as a guide, inspect the wiring and connectors for damage.

• Turn the ignition on.

• With the scan tool, read active PCM DTCs.

Does the scan tool display any active battery or charging DTCs?

Yes

• Perform the appropriate charging system diagnostic procedure.

No

• Check the above conditions that can cause a low voltage condition. Repair as necessary.

• Perform the Body Verification Test. Refer to => Non-DTC Based Diagnostics. Body Interior