Left Rear Door Module
B210E - Battery Voltage High
For a complete wiring diagram, refer to.
• When Monitored: At all times.
• Set Condition: The module senses voltage input above 16.5 volts for over 15 seconds.
Test Step 1 - CHECK ENGINE DTCs
• Start the engine and run for two minutes.
• With the scan tool, read the active ENGINE DTCs.
Are there any active ENGINE Charging or Battery DTCs present?
No
• Go to Test Step 2
Yes
• Perform the appropriate diagnostic procedure.
Test Step 2 - TEST FOR INTERMITTENT CONDITION
• With the scan tool, erase all DTCs.
• Make sure the engine is still running.
• With the scan tool, read the active door module DTCs.
Does the scan tool display active: B210E-BATTERY VOLTAGE HIGH?
Yes
• Replace the Door Module.
• Perform the Body Verification Test. Refer to => Non-DTC Based Diagnostics. Body Interior
No
• Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension.
• Perform the Body Verification Test. Refer to => Non-DTC Based Diagnostics. Body Interior