Wireless Ignition Node

B222A - Vehicle Line Mismatch

For a complete wiring diagram, refer to.

• When Monitored: Anytime the ignition key is in the ON position.

• Set Condition: If the intrusion transceiver module is not configured.






Test Step 1 - Configure the Intrusion Transceiver Module

• Using the scan tool under miscellaneous functions perform the initialization procedure for the ITM.

• With the scan tool, clear DTCs.

• Turn the ignition OFF and remove the key from the ignition.

• Lock and close all doors to allow the vehicle theft security system to go from pre-arm to armed status and wait one minute.

• Disarm the VTSS.

• Using the scan tool, read DTCs.

Does the DTC reset?

Yes

• Replace the intrusion transceiver module.

• Perform the Body Verification Test. Refer to => Non-DTC Based Diagnostics. Body Interior

No

• Test complete.

• Perform the Body Verification Test. Refer to => Non-DTC Based Diagnostics. Body Interior