DVD

B222C-Vehicle Configuration Not Programmed

For a complete wiring diagram, refer to.

• When Monitored: With the ignition on.

• Set Condition: Vehicle configuration information not programmed into the Instrument Cluster.






Test Step 1 - TEST FOR AN INTERMITTENT CONDITION

• Turn the ignition on.

• With the scan tool, record and erase any Instrument Cluster DTCs.

• Turn the ignition off, wait ten seconds then turn the ignition on.

• With the scan tool, read DTCs.

Does the scan tool display: B222C-VEHICLE CONFIGURATION NOT PROGRAMMED?

Yes

• Go to Test Step 2 => [ Test Step 2 - VERIFY COMMUNICATION WITH TOTALLY INTEGRATED CONTROL
MODULE (TIPM) ]

No

• The condition that caused this code to set is not present at this time. Using the wiring diagram as a guide, inspect the wiring and connectors for an intermittent condition. Operate the system several times and recheck for active DTCs.

• Perform the Body Verification Test. Refer to => Non-DTC Based Diagnostics. Body Interior

Test Step 2 - VERIFY COMMUNICATION WITH TOTALLY INTEGRATED CONTROL MODULE (TIPM)

• With the scan tool in ECU VIEW, read active modules on the bus.

Does the scan tool show the Totally Integrated Control Module active on the bus?

Yes

• Go to Test Step 3 => [ Test Step 3 - CHECK TOTALLY INTEGRATED CONTROL MODULE FOR ACTIVE
DTCS ]

No

• Refer to => Non-DTC Based Diagnostics and perform the appropriate No Response diagnostic procedure.

Test Step 3 - CHECK TOTALLY INTEGRATED CONTROL MODULE FOR ACTIVE DTCS

• With the scan tool, erase TIPM DTCs.

• Turn the ignition off. Wait approximately ten seconds.

• Turn the ignition on.

• With the scan tool, read TIPM DTCs.

Are any active DTCs present?

Yes

• Refer to => Electrical System DTC Based Diagnostics and perform the appropriate diagnostic procedure.

No

• Go to Test Step 4 => [ Test Step 4 - CHECK CLUSTER VEHICLE INFORMATION WITH SCAN TOOL ]

Test Step 4 - CHECK CLUSTER VEHICLE INFORMATION WITH SCAN TOOL

• With the scan tool in Cluster ECU Identification, read the Original and Current VINs, and the Body Style of the vehicle.

Does the information displayed match the vehicle?

Yes

• Replace the Instrument Cluster in accordance with the Service Information.

• Perform the Body Verification Test. Refer to => Non-DTC Based Diagnostics. Body Interior

No

• Replace the Totally Integrated Control Module in accordance with the Service Information.

• Perform the Body Verification Test. Refer to => Non-DTC Based Diagnostics. Body Interior