Video Entertainment System (VES3)

B222C-Vehicle Configuration Not Programmed

For a complete wiring diagram, refer to.

• When Monitored: With the ignition on.

• Set Condition: Vehicle configuration information not programmed into the TIPM.






Test Step 1 - TEST FOR AN INTERMITTENT CONDITION

• Turn the ignition on.

• Turn the ignition off, wait ten seconds then turn the ignition on.

• With the scan tool, read DTCs.

Does the scan tool display: B222C-VEHICLE CONFIGURATION NOT PROGRAMMED?

Yes

• Go to Test Step 2 => [ Test Step 2 - VERIFY COMMUNICATION WITH TIPM ]

No

• Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension.

• Perform the Body Verification Test. Refer to => Non-DTC Based Diagnostics. Body Interior

Test Step 2 - VERIFY COMMUNICATION WITH TIPM

• With the scan tool, read the active modules on the bus.

Does the scan tool show the TIPM active on the bus?

Yes

• Go to Test Step 3 => [ Test Step 3 - CHECK TIPM FOR ACTIVE DTCS ]

No

• Refer to => Non-DTC Based Diagnostics and perform the No Response from TIPM diagnostic procedure. Testing and Inspection

Test Step 3 - CHECK TIPM FOR ACTIVE DTCS

• With the scan tool, erase TIPM DTCs.

• Turn the ignition off. Wait approximately ten seconds.

• Turn the ignition on.

• With the scan tool, read TIPM DTCs.

Are any active DTCs present?

Yes

• Refer to => Electrical System DTC Based Diagnostics and perform the appropriate diagnostic procedure.

No

• Go to Test Step 4 => [ Test Step 4 - CHECK THE VEHICLE CONFIGURATION INFORMATION WITH SCAN
TOOL ]

Test Step 4 - CHECK THE VEHICLE CONFIGURATION INFORMATION WITH SCAN TOOL

• With the scan tool run an ECU Details Report, read the Original and Current VINs, and the Body Style of the vehicle.

Does the information displayed match the vehicle?

Yes

• Replace the Totally Integrated Power Module (TIPM).

• Perform the Body Verification Test. Refer to => Non-DTC Based Diagnostics. Body Interior

No

• Go to Test Step 5 => [ Test Step 5 - RESTORE THE VEHICLE CONFIGURATION ]

Test Step 5 - RESTORE THE VEHICLE CONFIGURATION

• With the scan tool, restore the vehicle configuration.

• Turn the ignition off, then back on.

• With the scan tool, read the active DTCs.

Does the scan tool display B222C-VEHICLE CONFIGURATION NOT PROGRAMMED as active?

Yes

• Replace the Totally Integrated Power Module (TIPM).

• Perform the Body Verification Test. Refer to => Non-DTC Based Diagnostics. Body Interior

No

• Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension.

• Perform the Body Verification Test. Refer to => Non-DTC Based Diagnostics. Body Interior