Passive Entry Module

B223B-00-Vehicle Configuration Mismatch

For a complete wiring diagram, refer to.

• When Monitored: Whenever a Passive Entry or Keyless Start event is actuated.

• Set Condition: When a Passive Entry or Keyless Start event is actuated and the PEM receives an incorrect configuration message, it will set this code after three activated events.

• Do not attempt to swap PEM modules. If a PEM module has been used on one vehicle, it cannot be used on another vehicle.






Test Step 1 - CHECK MODULE CONFIGURATION

• If there are any PEM handle or antenna DTCs, perform the diagnostic procedure for them before continuing.

• Make sure the battery is fully charged.

• Using the Push Button, turn the ignition on.

• Using the scan tool, record and erase the DTCs.

• Using the Push Button, cycle the ignition three times waiting two seconds between cycles.

• Turn the ignition on.

• With the scan tool, check the active PEM DTCs.

Does the scan tool display: B223B-00-VEHICLE CONFIGURATION MISMATCH as active?

Yes

• Go to Test Step 2

No

• Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension.

• Perform the Body Verification Test. Refer to => Non-DTC Based Diagnostics. Body Interior

Test Step 2 - CHECK MODULE CONFIGURATION

• With the scan tool, select: PEM, "Reports", "Configuration Report", "PEM".

• Record the Vehicle Line and the Driver (side) (LHD/RHD) reported by the PEM.

• Select "Configuration Report", "TIPM".

Does the configuration report for PEM match the TIPM report?

Yes

• Replace the Passive Entry Module.

• Perform the Body Verification Test. Refer to => Non-DTC Based Diagnostics. Body Interior

No

• Go to Test Step 3

Test Step 3 - TIPM CONFIGURATION

• Look over the vehicle and check the Vehicle Line and the Driver (side) (LHD/RHD).

• Compare the PEM configuration report to the actual vehicle (Vehicle line & Drivers side).

Does the PEM configuration report match the actual vehicle?

Yes

• With the scan tool, check the TIPM for any Vehicle Configuration DTCs.

• Perform the Body Verification Test. Refer to => Non-DTC Based Diagnostics. Body Interior

No

• Replace the Passive Entry Module.

• Perform the Body Verification Test. Refer to => Non-DTC Based Diagnostics. Body Interior