Operation CHARM: Car repair manuals for everyone.

B2563






B2563 - Power Sliding Door Switch Circuit High






For a complete wiring diagram, refer to.

When Monitored: Whenever the cluster is awake.

Set Condition: When the cluster senses voltage over 6 volts on the sliding doors overhead switch MUX circuit for longer than 10 seconds, this code will set.






Test Step 1 - DTC Present

With the scan tool, record DTCs.

Erase DTCs

Turn the ignition OFF, wait 10 seconds, then turn the ignition ON.

Operate the left power sliding door several times from the left power sliding door B - pillar switch.

With the scan tool, read DTCs.

Does the scan tool display this DTC as active?

Yes

Go to Test Step 2 => [ Test Step 2 - Check Sliding Doors Overhead Switch MUX Circuit for
a Short to Voltage ]

No

Using the wiring diagram/schematic as a guide, inspect the wiring and connectors for an intermittent condition.

Perform the Body Verification Test. Refer to => Non - DTC Based Diagnostics. Body Interior

Test Step 2 - Check Sliding Doors Overhead Switch MUX Circuit for a Short to Voltage






Disconnect the switch - bank - No. 2 (PREMIUM) - 8 way harness connector.

Turn the ignition ON.

Measure the voltage between ground and the sliding doors overhead switch MUX circuit in the switch - bank - No. 2 (PREMIUM) - 8 way harness connector.

Is the voltage above 5.9 volts?

No

Go to Test Step 3 => [ Test Step 3 - Check the Sliding Doors Overhead Switch MUX Circuit
for an Open ]

Yes

Go to Test Step 4 => [ Test Step 4 - Check the Sliding Doors Overhead Switch MUX Wire for
a Short to Voltage ]

Test Step 3 - Check the Sliding Doors Overhead Switch MUX Circuit for an Open






Turn the ignition OFF.

Disconnect the instrument cluster C2 harness connector.

Measure the resistance of the sliding doors overhead switch MUX circuit between the switch - bank - No. 2 (PREMIUM) - 8 way harness connector and the instrument cluster C2 connector.

Is the resistance below 5.0 ohms?

No

Repair the sliding doors overhead switch MUX circuit for an open.

Perform the Body Verification Test. Refer to => Non - DTC Based Diagnostics. Body Interior

Yes

Replace the instrument cluster.

Perform the Body Verification Test. Refer to => Non - DTC Based Diagnostics. Body Interior

Test Step 4 - Check the Sliding Doors Overhead Switch MUX Wire for a Short to Voltage






Turn the ignition ON.

Measure the voltage between ground and the sliding doors overhead switch MUX circuit in the switch - bank - No. 2 (PREMIUM) - 8 way harness connector.

Is there any voltage present?

Yes

Repair the sliding doors overhead switch MUX circuit for a short to voltage.

Perform the Body Verification Test. Refer to => Non - DTC Based Diagnostics. Body Interior

No

Replace the instrument cluster.

Perform the Body Verification Test. Refer to => Non - DTC Based Diagnostics. Body Interior