C1210

C1210 - G Sensor Input Circuit Performance

For a complete wiring diagram, refer to.

• When Monitored: Continuously, with ignition ON, until vehicle speed exceeds 20 km/h (12.4 m.p.h.) for the first time, but not if the sensor voltage is out of range OR, during diagnostic mode OR, if the monitoring was inhibited by a corresponding diagnostics command.

• Set Condition: If the measured acceleration signal is higher than 0.8 g for longer than the specified detection time.






Test Step 1 - Test for DTC C1210 - G Sensor Input Circuit Performance

• This DTC must be active for the results of this test to be valid.

• Turn the ignition ON.

• With the scan tool, read and record DTCs.

• With the scan tool, read and record information.

• With the scan tool, erase DTCs.

• Cycle the ignition switch from OFF to ON.

• With the scan tool, read and record DTCs.

Does the scan tool display C1210 - G Sensor Input Circuit Performance?

Yes

• Replace the Dynamics Sensor.

• Perform ABS Verification Test. Refer to => Non-DTC
Based Diagnostics. ABS Verification Test

No

• Perform the Intermittent Condition diagnostic procedure. Refer to => Non-DTC Based Diagnostics.